When providing CNC Machining Service
, The division of CNC machining operations can generally be carried out as follows:
(1) In the rough and fine processing, the parts that are prone to processing deformation need to be shaped due to the deformation that may occur after roughing. Therefore, in general, the rough and fine machining must be separated. .
(2) Sorting method of processing parts For parts such as CNC Aluminum Parts
with a lot of processing contents, the processing part can be divided into several parts according to its structural characteristics, such as inner shape, shape, curved surface or plane. Generally, the plane, the positioning surface, and the rear processing hole are first processed; the simple geometric shape is processed first, and the complex geometric shape is processed; the lower precision part is processed first, and the processing precision requirement is higher.
(3) The tool concentration sorting method is to divide all the parts that can be completed on the part with the same tool according to the dividing process of the tool used. Use the second knife and the third handle to complete other parts that they can complete. This reduces the number of tool changes, compresses the dead time, and reduces unnecessary positioning errors.
In summary, it is understood that in the division process, it must be based on the structure and process of the part, the function of the machine tool, the number of CNC Machined Turning
parts, the number of installations and the unit's production organization status. It is also recommended to adopt the principle of process concentration or the principle of process dispersion, which should be determined according to the actual situation, but it must be reasonable.
Only when the process division is reasonable, can the CNC machining center create the maximum efficiency. Is your CNC machining process reasonable for the profit of your own factory?